MIL-STD-461E 2|=_kN8; %aKkk)s MIL-STD-461E: "DOD Interface Standard Requirements for the Control of Electromagnetic Interference Characteristics of Subsystems and Equipment" was published on August 20, 1999 and consolidates MIL-STD-461D and MIL-STD-462D into one Standard. The associated Data
ITem Descriptions (DIDs) are as follows:
(J4utw Z 8bGq"!w- DID NUMBERDID TITLE } 8P}L@q ]xG8vy DI-
EMCS-80199B Electromagnetic Interference Control Procedures (EMICP)
k:TfE6JZ DI-
EMCS-80200B Electromagnetic Interference Test Report (EMITR)
zEB1Br, DI-EMCS-80201B Electromagnetic Interference Test Procedures (EMITP)
*X\c
$=* 8joQPHkI\ Major changes MIL-STD-461D/462D to MIL-STD-461E: H5s85"U# O0~d6Ba isc]- EUT hardware and software must be representative of production. Susceptibility scan rates and the frequency of measurement system test checks were revised.
#H[4?4r kpH;D=
; · Conducted Emissions 5u46Vl{ dM UDLr- CE101: is no longer applicable to shipboard equipment
!_9$[Oq
~ Nd_@J&
· Conducted Susceptibility j/<y
S=}~I CS101: applicability and limits were extended to 150 kHz
nvPE
N CS109: measurement procedures were revised
GC[{=]}9U CS114: limits were revised
YfwJBzD CS115: applicability was revised for several equipment classes
fmJW d
| CS116: measurement procedures were revised;
XO#)i6}G applicability was revised for several equipment classes
@;fE%N =
Y-Ne6a · Radiated Emissions nb_^3K]r &fW=5' RE101: the 50 cm requirement was deleted; limits are more stringent
8-a6Q|
RE102: limits were revised for submarine equipment
51
0XDl~b B bw1k · Radiated Susceptibility P\4tK<P| !t
Oky RS101: limits were revised for Navy applications; added an alternative test using the Helmholtz coil
,/6:bc:W RS103: added use of mode-tuned reverberation chambers above 200 MHz
RVnyl`s RS105: limits were revised for consistency with
IEC Standards
2 dD<] ZQ9oZHU m 文章出自: 世科网 :6$4K"^1 0BB@E(*