[标准综合]MIL-STD-461E与461D的区别 [复制链接]

  MIL-STD-461E c4oQ4  
j`A%(()d  
MIL-STD-461E: "DOD Interface Standard Requirements for the Control of Electromagnetic Interference Characteristics of Subsystems and Equipment" was published on August 20, 1999 and consolidates MIL-STD-461D and MIL-STD-462D into one Standard. The associated Data ITem Descriptions (DIDs) are as follows: jpZ, $  
7jT]J  
DID NUMBERDID TITLE LY[XPV]t  
*VH!<k[n  
DI-EMCS-80199B Electromagnetic Interference Control Procedures (EMICP) u?Jw)
`  
DI-EMCS-80200B Electromagnetic Interference Test Report (EMITR) kDS  
DI-EMCS-80201B Electromagnetic Interference Test Procedures (EMITP) `uy)][j-  
x):cirwkl  
Major changes MIL-STD-461D/462D to MIL-STD-461E: "tB"C6b  
L6Ykv/V  

isc]
1. EUT hardware and software must be representative of production. Susceptibility scan rates and the frequency of measurement system test checks were revised.

oCdWf63D  
bsy\L|wd  
· Conducted Emissions -?`^^v  
$5ZBNGr  
CE101: is no longer applicable to shipboard equipment $^?"/;8P5  
fOCLN$x^  
· Conducted Susceptibility 1X2MhV  
,\q9>cZ!  
CS101: applicability and limits were extended to 150 kHz ;<d("Yz:@Z  
CS109: measurement procedures were revised HtB>
#`'  
CS114: limits were revised wl H6  
CS115: applicability was revised for several equipment classes oBiJiPE=`  
CS116: measurement procedures were revised; ec+&K?T  
applicability was revised for several equipment classes Gs;wx_k^  
w%R(*,r6  
· Radiated Emissions os0fwv  
S[(Tpk2_  
RE101: the 50 cm requirement was deleted; limits are more stringent d\dh"/_$  
RE102: limits were revised for submarine equipment ]:jP*0bLx  
b{J
cV  
· Radiated Susceptibility .1<QB{4~v  
=i[_C>U  
RS101: limits were revised for Navy applications; added an alternative test using the Helmholtz coil H<41H;m  
RS103: added use of mode-tuned reverberation chambers above 200 MHz '4k l$I  
RS105: limits were revised for consistency with IEC Standards 3y?I^ .B  
4FUY1p  
文章出自: 世科网 r(WR=D{  
ChzKwYDY