[标准综合]MIL-STD-461E与461D的区别 [复制链接]

  MIL-STD-461E gP 6`q  
wc7F45
l4  
MIL-STD-461E: "DOD Interface Standard Requirements for the Control of Electromagnetic Interference Characteristics of Subsystems and Equipment" was published on August 20, 1999 and consolidates MIL-STD-461D and MIL-STD-462D into one Standard. The associated Data ITem Descriptions (DIDs) are as follows: RFzMah?Q=j  
sg!*%*XQ  
DID NUMBERDID TITLE TDnbX_xC<  
u{"@ 4  
DI-EMCS-80199B Electromagnetic Interference Control Procedures (EMICP) UZq1qn@+  
DI-EMCS-80200B Electromagnetic Interference Test Report (EMITR) A7X-),D  
DI-EMCS-80201B Electromagnetic Interference Test Procedures (EMITP) YDMimis\H5  
rt7]~W-  
Major changes MIL-STD-461D/462D to MIL-STD-461E: sXaIQhZ  
m+m,0Ey5H  

isc]
1. EUT hardware and software must be representative of production. Susceptibility scan rates and the frequency of measurement system test checks were revised.

{,aI0bw;  

\|}dlG  
· Conducted Emissions 0H-~-z8Y  
!awfxH0  
CE101: is no longer applicable to shipboard equipment Hi 1@  
~Zc=FP:1  
· Conducted Susceptibility -U?Udmov  
&O' 6va  
CS101: applicability and limits were extended to 150 kHz %U&O \GB  
CS109: measurement procedures were revised Z. ))=w6G  
CS114: limits were revised `N_elf://n  
CS115: applicability was revised for several equipment classes vap,)kILF  
CS116: measurement procedures were revised; iINd*eXb^  
applicability was revised for several equipment classes }dl[~iKW  
2 g elmQnc  
· Radiated Emissions v)*/E'Cr*  
>~-8RM  
RE101: the 50 cm requirement was deleted; limits are more stringent hjVct r  
RE102: limits were revised for submarine equipment QxRT%;'Zh]  
V _(L/6  
· Radiated Susceptibility <l/QS3M  
h0}=C_.^  
RS101: limits were revised for Navy applications; added an alternative test using the Helmholtz coil Zd~'%(q  
RS103: added use of mode-tuned reverberation chambers above 200 MHz ~=$0=)c  
RS105: limits were revised for consistency with IEC Standards toDv~v  
CH!>RRF  
文章出自: 世科网 ETt7?,x@  
pKe K6K\8